Bearing Buddy Bearing Protectors provide protection against damage from water and dirt entering the wheel bearings and make lubricating bearings a snap.
Auto Check feature allows you to see when it's time to add grease. These also includes a pair of bras.
Model No. 2441
Chrome plated. For use with 2.441 inches (62.00 mm) hub bore,
Outer Bearing Cone: LM-67048, hub counterbored, 15123 and others,
Outer Bearing Cup (race): LM-67010, 15245
weight : 1.50 lbs.
Bra Model 23B
Fits Bearing Buddy® model no. 2328, 2441, 2717, 2562, 2240
weight : 0.15 lbs.
When you want to protect your trailer axle bearings, there’s no better choice than Bearing Buddy®. This set of two protectors is designed for 5.2K to 6K trailer axles, and each piece will guard your bearings against dirt, water, and debris. Each set that you order comes with two chrome-plated protectors and two rubber bras that fit over the protectors. They’re easy to install and the Auto-Check feature lets you know when it’s time to grease your axles. At The Trailer Parts Outlet, we’re here to make sure you have access to the best products on the market. Order your new Bearing Buddy® Protectors online today!
2.441 inch diameter (Approx. 2-7/16")
Prevents wheel bearing failure on boat, snowmobile, ATV, horse, RV and utility trailers
Eliminates bearing repacking - Keeps water and dirt out of hubs and bearings
Stainless steel components - Easy to install
Please see measurement instructions (secondary picture) to confirm correct sizing.
- Bearing and Seal Inspection
- Remove Hubs and Check the Bearings before installing Bearing Buddy.
- Replace Bearings if they are damaged, rusted or pitted.
- Clean old great and contaminants out of the hubs. Check the condition of the inner seals. Be sure they are new , top quality, and running on a smooth spindle sealing surface.
- Important: As you reassemble the components, fill the hubs completely with a high quality, multipurpose no 2 grade lubricant (the type used for automotive suspensions). Do not use heavy, fibrous greases; don't mix grease types.
- Genuine Bearing Buddy Installation
- Hold the Bearing Buddy against the hub with a small block of wood, and drive it into place with a hammer. If Bearing Buddy cannot be driven into the hub, or will not fit tightly into the hub, don't force it. Your hubs may be slightly oversized or undersized.If this occurs, or if the Bearing Buddy is obviously too large or too small; contact us at 936-349-6507.
- How to Remove a Bearing Buddy
- Bearing Buddy is held in the hub by an interference hit.
- To remove Bearing Buddy®, lay a block of wood against the side of it and strike the wood with a hammer. Place the wood on the opposite side and hit again.
- Continue this procedure until you ''walk'' the Bearing Buddy® out of the hub. Don't disassemble the Bearing Buddy® to attempt to remove it.